TSC TE200 Label Software for Mac & Windows

Compatibility evidence: Protocol-compatible

Official manufacturer documentation shows a native or emulated command language supported by LabelInn. This exact model has not been physically tested or observed in production.

TSC's official TE200 documentation verifies 203 DPI, 108 mm print width, USB, optional Bluetooth, and TSPL-EZD with ZPL II/EPL/DPL compatibility. LabelInn has not physically tested or production-observed this exact model.

What LabelInn supports

economical 4-inch product, warehouse and shipping labels with ribbon support. The TE200 is the 203 DPI base model of TSC's TE200 family, with a 108 mm print width and TSPL-EZD firmware. Official material lists USB as the hardwired interface and Bluetooth as an option, so Ethernet and Wi-Fi should not be assumed from a similar TE-series suffix.

• TSPL-EZD (native), ZPL II (emulation), EPL2 (emulation), DPL (emulation) output at the selected resolution.
• Direct command printing is supported when an available interface is selected.
• Choose 203 DPI TSPL-EZD, match direct-thermal or ribbon transfer mode to the loaded media, and use USB unless the exact unit has the documented Bluetooth option. LabelInn does not require a macOS print driver on its direct protocol path.

Setup checklist

1. Confirm the complete model name, suffix, installed interface, and current command-language mode.
2. Set the page DPI and printable width to match the physical printhead.
3. Load the correct media; if applicable, match ribbon mode and sensor type.
4. Print a small calibration label before sending a production batch.

Operating-system notes

Windows — Supported

Use either the operating-system print path or direct protocol output when this record marks direct printing as supported.

macOS — Conditional

Direct protocol output avoids a model-specific print driver when the selected connection is available to macOS.

Android — Conditional

Android support is conditional on a supported USB, Bluetooth, or network path; the production observation did not record which path was used.

Common configuration problems

• Assuming Ethernet from another TE-series variant prevents discovery of a USB-only unit.
• A ribbon/media mode mismatch produces blank or weak output even when data reaches the printer.

Printer troubleshooting →